In 1960, Seiko set itself a challenge to make the thinnest mechanical dress watch it could. The result was the Goldfeather, which Credor — Seiko’s luxury-focused watchmaking sibling within the Seiko Group — brought back in 2023. The collection now runs to about 10 references, and the slim case is what ties them together, even when Credor gets a little carried away. On one model, you can see a pattern cut into silver through layers of blue enamel. On another, the hour markers are built up in lacquer and dusted with platinum powder. Then there’s the one with an exposed tourbillon and engraving on the front and back. Even that one is only 8.6mm thick.

We got a closer look at Credor’s ultra-thin watchmaking at its first Watches and Wonders in April, where it showed the new, blue-lacquer GBBY967 and the engraved GBCF997 tourbillon. We also saw the enamel-dialed GBBY969, which came out in Japan last fall. It shares its 37.4mm platinum case design and hand-wound movement with the lacquered model, so most of what sets the two apart is right there on the dial. Even with a movement roughly twice as thick as those two models’, the tourbillon is only half a millimeter thicker than the lacquered model.
From Seiko to Credor

The original Goldfeather came out in 1960, the same year as the first Grand Seiko. Seiko was after accuracy with one and thinness with the other. The Goldfeather’s Caliber 60 measured 2.95mm thick, which Seiko says made it the thinnest mechanical movement with a central seconds hand at the time. Seiko went thinner in 1969 with the Ultra Thin Dress, or U.T.D. Its two-hand Caliber 6800 was just 1.98mm thick and started a family of movements that would outlast the original Goldfeather. Seiko used its successor, the Caliber 6810, in some of the high-end watches that laid the groundwork for Credor.

Seiko officially established Credor in 1974 and built it around watches in precious metals. By 1993, Credor was making dress watches with the ultra-thin Caliber 6870, and three years later it used another 68-series movement in a skeletonized watch with a bamboo motif. In 2006, Credor introduced the Spring Drive Sonnerie, which chimed the hours on a small bell of the kind used in Japanese temples, and two years later came the Eichi — a porcelain-dial Spring Drive dress watch that became one of Credor’s best-known models.
When Credor revived the Goldfeather in July 2023, it brought back the script from the 1960 watch and paired it with the hand-wound Caliber 6890. More than half a century after the U.T.D., the movement was still 1.98mm thick.
The Goldfeather GBBY969 and GBBY967
Credor takes the “feather” in Goldfeather pretty literally. On the GBBY969 and GBBY967, the lugs are slender and curve down toward the wrist, and the narrow bezel leaves most of what you see to the dial. A box-shaped sapphire crystal rises above the bezel, echoing the profile of the original 1960 Goldfeather. Both cases are made of 950 platinum and measure 37.4mm across and 43.2mm lug to lug. There’s only 0.2mm between them in profile. The enamel GBBY969 is 8.3mm thick, and the lacquer GBBY967 is 8.1mm. Both have display backs and come on crocodile straps with platinum pin buckles.

The distinction between the two is in the dial. The GBBY969 starts with a fine pattern machine-engraved into pure silver. Ando Cloisonné — a longtime Owari Shippo enamel workshop — applies and fires layers of translucent enamel over the silver. You can see the pattern most clearly at the center, where the blue is lighter. It deepens to indigo at the edge, a shade Credor calls Tomekon after a color used in Japanese dyeing. The slim applied hour markers leave most of the pattern in view, and with just two hands there’s little else to get in the way.

On the GBBY967, the blue goes all the way to black at the edge. That gradient comes from layers of urushi lacquer, polished with whetstones between applications. Blue is uncommon in traditional urushi work, and Credor adjusted the shade several times to get it to blend into the black. The dial is slightly curved, so the artisan changes the angle of polishing as they work across it.

The GBBY967’s hour markers and the Credor and Goldfeather signatures are done in taka maki-e. The artisan builds up the shapes in lacquer, then dusts them with platinum powder. Gold and silver are more common, and platinum is harder to finish. To polish the raised marks, the artisan uses metal spatulas alongside a traditional tool made from a sea bream tooth. It’s a lot of work for a few letters and twelve little marks.

Turn either watch over, and you’ll see the hand-wound Caliber 6890. It’s 1.98mm thick, has 22 jewels, and runs at 21,600 vibrations per hour, with about 37 hours on a full wind. Piaget’s 430P, used in the Altiplano, is a touch thicker at 2.1mm and runs for about 43 hours. Vacheron Constantin’s Caliber 1003, used in the Historiques Ultra-Fine 1955, is thinner at 1.64mm and gives you about 31 hours. You’ll have to reset the Goldfeather after a weekend off the wrist, but 37 hours feels like a fair trade for a dress watch made to slip under a cuff.
The Goldfeather GBCF997 Tourbillon
Credor gives the tourbillon more room than the two blue Goldfeathers. The GBCF997 measures 38.6mm across and 45.2mm lug to lug, with a hand-polished platinum case and a crocodile strap with a push-button platinum folding clasp. Fine engraved lines fan out across the silver-toned dial, with the tourbillon turning in an opening on the left.

Those lines run across two layers of the dial and have to line up when the pieces are fitted together. The slim Roman numerals are engraved, too, and take their shape from hand-drawn numerals Credor used in the 1970s. Look closer at the minute track, and you’ll also see that it’s made up of individual engraved dots. Each is cut with a rounded chisel in a Japanese engraving technique called nanako.

Even with the tourbillon out in the open, the dial-side engraving reflects the Goldfeather collection’s affinity for minimalism, though Credor loosens up a little when you flip the watch over. Long cuts radiate from the tourbillon carriage, crossing three movement components and a crescent-shaped decorative plate. Each line takes several passes, and the engraver has to hold the angle and depth steady so the cuts line up across all four pieces. Between the lines are more nanako dots and scattered marks made with a hexagonal chisel.
The hand-wound Caliber 6850 first appeared in the Goldfeather tourbillon GBCF999 in 2025. At 25.6mm across and 3.98mm thick, it’s the same size as Credor’s earlier Caliber 6830. A larger mainspring barrel brings the reserve to about 60 hours, nearly a day more than you get from the two-hand Goldfeathers. For comparison, the hand-wound 670P in Piaget’s Altiplano Tourbillon measures 4.6mm thick and runs for about 48 hours. Bulgari goes much thinner with the 1.95mm BVL 268 in the Octo Finissimo Tourbillon, which has a 52-hour reserve.
Final Thoughts and Pricing

The enamel GBBY969 and lacquer GBBY967 both list for ¥5,500,000 in Japan, including tax. The lacquer model’s U.S. launch price was $47,000, and the engraved tourbillon’s was $215,000. The lacquer model and the tourbillon are each limited to 25 pieces.
The blue Goldfeathers make for the closer decision. On the enamel model, the pattern under the blue is part of what you see every time you look down. The lacquer model is a bit quieter, with most of its detail in the raised markers and lettering. The tourbillon gives you the most to look at, especially through the back, where the engraving carries from one part of the movement to the next.
What I like about Credor’s take on ultra-thin watchmaking is that all three still have the charm of a classic dress watch. There’s plenty to get into up close, but even the tourbillon has the proportions of the slim watch Seiko set out to make in 1960. The Goldfeather is a good place to start getting to know Credor, even if most of us will do that from the other side of the display case.
For more information, visit the brand's website here.



































-(1).jpg?v=1795110352536)
Be the first to leave a comment
Log in or to leave a comment